Astro Machine AstroJet M1 Guide de dépannage télécharger pdf (Page 24)

SECTION 2

INSTALLING THE PRINTER

Setting up the Feed

The Printer is equipped with four Sheet Separators, two Side Guides and a Rear Media Guide. The Sheet

Separators are adjusted individually as follows:

1. Move the Left-hand Side Guide into position. This Guide has two positions. The position closest

to the Side Frame is for 9.5" media and the position closest to the center of the Printer is for

printing 8.5" wide media edge to edge.

2. Loosen the locking screws located behind

the Sheet Separators and raise the

Separators, then tighten the locking screws

to hold the Separators in the “Up” position.

3. Place a single piece of the media to be run

under the Separators. Always place the

media against the Left-hand Paper Guide.

Loosen the Separator locking screw and

allow the Separator to settle onto the media.

Then tighten the locking screw. Repeat for

each Separator.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Pas de commentaire

Astro Machine AstroJet M1 Guide de dépannage Page 24